Power Supply PCB for Soundcraft Spirit E6, Spirit E8, and Spirit E12 Mixing Consoles
I recently came into the possession of a Soundcraft Spirit e12 with a dead power supply. While the e12 was a bit tedious to disassemble, the R-S2006A-05-SP power supply mounted easily in place of the old supply, and the mixer is back working again.
This part had an additional heat sink and some hot-glue to stabilize the capacitors that were missing on the original (all of which is visible in the photo above), dead supply. Presumably, over the years the manufacturer found that the old power supply's build wasn't good enough. Since that supply died, I have to assume that they're correct. :)
Note that as supplied, the mounting screw holes in this power supply are not threaded. The mounts are a soft plastic though, and you can thread the existing screws into the mounts just by screwing them in.
This power supply DOES come with the fuse mounted, which was a nice touch. It also comes with a plastic protector for the bottom of the supply, to help prevent short circuits.